AI PCPer-segment measurement
About every 5 minutes, lightly measures response times to the router, DNS server and internet, just a few times each.
Internet keeps dropping? Find out who's to blame
A one-off speed test rarely catches a problem that only shows up in the evening.
Record each segment for a few days, and it becomes clear whether it's your router or your ISP.
What it does
Cause by time of day
If internet loss rises only at certain hours while the router stays clean, it points to congestion on the ISP side.
Wi-Fi jitter
High jitter to the router means Wi-Fi interference; on a wired connection, it points to the cable or router.
Light, and you can turn it off
Keeps only numbers and connection type for 14 days, and can be switched off anytime on the dashboard.
How to use it
- 1
Make sure recording is on in the "Network quality" card on the dashboard.
- 2
Use your PC as usual for a day or two.
- 3
Check latency and loss by hour and which segment has the problem.
FAQ
What should I tell my ISP?
Pass on the recorded numbers as they are, for example: internet-side loss of a certain percent between two times, while the router was fine at the same time.
Does it use much data?
No. Each round sends only about a dozen small connections and queries, so the data used is negligible.
Get started for free
After installing, click the tray icon and your first diagnosis is already done.
Every change runs only after you confirm it, and can be undone.